PCI: dwc: Ensure that dw_pcie_wait_for_link() waits 100 ms after link up

As per PCIe r6.0, sec 6.6.1, a Downstream Port that supports Link speeds
greater than 5.0 GT/s, software must wait a minimum of 100 ms after Link
training completes before sending a Configuration Request.

Add this delay in dw_pcie_wait_for_link(), after the link is reported as
up. The delay will only be performed in the success case where the link
came up.

DWC glue drivers that have a link up IRQ (drivers that set
use_linkup_irq = true) do not call dw_pcie_wait_for_link(), instead they
perform this delay in their threaded link up IRQ handler.

Signed-off-by: Niklas Cassel <[email protected]>
Signed-off-by: Manivannan Sadhasivam <[email protected]>
Reviewed-by: Damien Le Moal <[email protected]>
Reviewed-by: Wilfred Mallawa <[email protected]>
Link: https://patch.msgid.link/[email protected]

1 files changed, 8 insertions, 0 deletions

diff --git a/drivers/pci/controller/dwc/pcie-designware.c b/drivers/pci/controller/dwc/pcie-designware.c
index 4d794964fa0f..053e9c540439 100644
--- a/drivers/pci/controller/dwc/pcie-designware.c
+++ b/drivers/pci/controller/dwc/pcie-designware.c
@@ -714,6 +714,14 @@ int dw_pcie_wait_for_link(struct dw_pcie *pci)
 		return -ETIMEDOUT;
 	}
 
+	/*
+	 * As per PCIe r6.0, sec 6.6.1, a Downstream Port that supports Link
+	 * speeds greater than 5.0 GT/s, software must wait a minimum of 100 ms
+	 * after Link training completes before sending a Configuration Request.
+	 */
+	if (pci->max_link_speed > 2)
+		msleep(PCIE_RESET_CONFIG_WAIT_MS);
+
 	offset = dw_pcie_find_capability(pci, PCI_CAP_ID_EXP);
 	val = dw_pcie_readw_dbi(pci, offset + PCI_EXP_LNKSTA);