PCI: endpoint: pci-epf-test: Add doorbell test support

Add doorbell support by allocating a dedicated BAR using the
pci_epf_alloc_doorbell() API and mapping the Endpoint MSI controller
message data address to it. The data to be written in the message address
is stored in the 'pci_epf_test_reg::doorbell_data' register. Finally, the
RC can trigger doorbell in the Endpoint by writing the content of
'doorbell_data' register to the offset specified in 'doorbell_offset' of
the 'doorbell_bar' BAR.

Triggering of the doorbell is detected by pci_epf_test_doorbell_handler(),
which is bound to the doorbell IRQ. On successful completion,
STATUS_DOORBELL_SUCCESS status is set in the above mentioned handler.

To avoid breaking compatibility between host and endpoint, add two new
commands: COMMAND_ENABLE_DOORBELL and COMMAND_DISABLE_DOORBELL.

The doorbell is allocated when COMMAND_ENABLE_DOORBELL command is called
and destroyed when COMMAND_DISABLE_DOORBELL is called.

This doorbell feature only works when both RC and EP drivers support it.
If one of them doesn't support the feature, the testcase will fail.

Signed-off-by: Frank Li <[email protected]>
[mani: code cleanups and reworded commit message]
Signed-off-by: Manivannan Sadhasivam <[email protected]>
Signed-off-by: Bjorn Helgaas <[email protected]>
Tested-by: Niklas Cassel <[email protected]>
Link: https://patch.msgid.link/[email protected]

0 files changed, 0 insertions, 0 deletions