igc: fix PTM cycle trigger logic

Writing to clear the PTM status 'valid' bit while the PTM cycle is
triggered results in unreliable PTM operation. To fix this, clear the
PTM 'trigger' and status after each PTM transaction.

The issue can be reproduced with the following:

$ sudo phc2sys -R 1000 -O 0 -i tsn0 -m

Note: 1000 Hz (-R 1000) is unrealistically large, but provides a way to
quickly reproduce the issue.

PHC2SYS exits with:

"ioctl PTP_OFFSET_PRECISE: Connection timed out" when the PTM transaction
  fails

This patch also fixes a hang in igc_probe() when loading the igc
driver in the kdump kernel on systems supporting PTM.

The igc driver running in the base kernel enables PTM trigger in
igc_probe().  Therefore the driver is always in PTM trigger mode,
except in brief periods when manually triggering a PTM cycle.

When a crash occurs, the NIC is reset while PTM trigger is enabled.
Due to a hardware problem, the NIC is subsequently in a bad busmaster
state and doesn't handle register reads/writes.  When running
igc_probe() in the kdump kernel, the first register access to a NIC
register hangs driver probing and ultimately breaks kdump.

With this patch, igc has PTM trigger disabled most of the time,
and the trigger is only enabled for very brief (10 - 100 us) periods
when manually triggering a PTM cycle.  Chances that a crash occurs
during a PTM trigger are not 0, but extremely reduced.

Fixes: a90ec8483732 ("igc: Add support for PTP getcrosststamp()")
Reviewed-by: Michal Swiatkowski <[email protected]>
Tested-by: Mor Bar-Gabay <[email protected]>
Tested-by: Avigail Dahan <[email protected]>
Signed-off-by: Christopher S M Hall <[email protected]>
Reviewed-by: Corinna Vinschen <[email protected]>
Signed-off-by: Jacob Keller <[email protected]>
Tested-by: Corinna Vinschen <[email protected]>
Acked-by: Vinicius Costa Gomes <[email protected]>
Signed-off-by: Tony Nguyen <[email protected]>

1 files changed, 41 insertions, 29 deletions

diff --git a/drivers/net/ethernet/intel/igc/igc_ptp.c b/drivers/net/ethernet/intel/igc/igc_ptp.c
index 946edbad4302..c640e346342b 100644
--- a/drivers/net/ethernet/intel/igc/igc_ptp.c
+++ b/drivers/net/ethernet/intel/igc/igc_ptp.c
@@ -974,13 +974,40 @@ static void igc_ptm_log_error(struct igc_adapter *adapter, u32 ptm_stat)
 	}
 }
 
+static void igc_ptm_trigger(struct igc_hw *hw)
+{
+	u32 ctrl;
+
+	/* To "manually" start the PTM cycle we need to set the
+	 * trigger (TRIG) bit
+	 */
+	ctrl = rd32(IGC_PTM_CTRL);
+	ctrl |= IGC_PTM_CTRL_TRIG;
+	wr32(IGC_PTM_CTRL, ctrl);
+	/* Perform flush after write to CTRL register otherwise
+	 * transaction may not start
+	 */
+	wrfl();
+}
+
+static void igc_ptm_reset(struct igc_hw *hw)
+{
+	u32 ctrl;
+
+	ctrl = rd32(IGC_PTM_CTRL);
+	ctrl &= ~IGC_PTM_CTRL_TRIG;
+	wr32(IGC_PTM_CTRL, ctrl);
+	/* Write to clear all status */
+	wr32(IGC_PTM_STAT, IGC_PTM_STAT_ALL);
+}
+
 static int igc_phc_get_syncdevicetime(ktime_t *device,
 				      struct system_counterval_t *system,
 				      void *ctx)
 {
-	u32 stat, t2_curr_h, t2_curr_l, ctrl;
 	struct igc_adapter *adapter = ctx;
 	struct igc_hw *hw = &adapter->hw;
+	u32 stat, t2_curr_h, t2_curr_l;
 	int err, count = 100;
 	ktime_t t1, t2_curr;
 
@@ -994,25 +1021,13 @@ static int igc_phc_get_syncdevicetime(ktime_t *device,
 		 * are transitory. Repeating the process returns valid
 		 * data eventually.
 		 */
-
-		/* To "manually" start the PTM cycle we need to clear and
-		 * then set again the TRIG bit.
-		 */
-		ctrl = rd32(IGC_PTM_CTRL);
-		ctrl &= ~IGC_PTM_CTRL_TRIG;
-		wr32(IGC_PTM_CTRL, ctrl);
-		ctrl |= IGC_PTM_CTRL_TRIG;
-		wr32(IGC_PTM_CTRL, ctrl);
-
-		/* The cycle only starts "for real" when software notifies
-		 * that it has read the registers, this is done by setting
-		 * VALID bit.
-		 */
-		wr32(IGC_PTM_STAT, IGC_PTM_STAT_VALID);
+		igc_ptm_trigger(hw);
 
 		err = readx_poll_timeout(rd32, IGC_PTM_STAT, stat,
 					 stat, IGC_PTM_STAT_SLEEP,
 					 IGC_PTM_STAT_TIMEOUT);
+		igc_ptm_reset(hw);
+
 		if (err < 0) {
 			netdev_err(adapter->netdev, "Timeout reading IGC_PTM_STAT register\n");
 			return err;
@@ -1021,15 +1036,7 @@ static int igc_phc_get_syncdevicetime(ktime_t *device,
 		if ((stat & IGC_PTM_STAT_VALID) == IGC_PTM_STAT_VALID)
 			break;
 
-		if (stat & ~IGC_PTM_STAT_VALID) {
-			/* An error occurred, log it. */
-			igc_ptm_log_error(adapter, stat);
-			/* The STAT register is write-1-to-clear (W1C),
-			 * so write the previous error status to clear it.
-			 */
-			wr32(IGC_PTM_STAT, stat);
-			continue;
-		}
+		igc_ptm_log_error(adapter, stat);
 	} while (--count);
 
 	if (!count) {
@@ -1255,7 +1262,7 @@ void igc_ptp_stop(struct igc_adapter *adapter)
 void igc_ptp_reset(struct igc_adapter *adapter)
 {
 	struct igc_hw *hw = &adapter->hw;
-	u32 cycle_ctrl, ctrl;
+	u32 cycle_ctrl, ctrl, stat;
 	unsigned long flags;
 	u32 timadj;
 
@@ -1290,14 +1297,19 @@ void igc_ptp_reset(struct igc_adapter *adapter)
 		ctrl = IGC_PTM_CTRL_EN |
 			IGC_PTM_CTRL_START_NOW |
 			IGC_PTM_CTRL_SHRT_CYC(IGC_PTM_SHORT_CYC_DEFAULT) |
-			IGC_PTM_CTRL_PTM_TO(IGC_PTM_TIMEOUT_DEFAULT) |
-			IGC_PTM_CTRL_TRIG;
+			IGC_PTM_CTRL_PTM_TO(IGC_PTM_TIMEOUT_DEFAULT);
 
 		wr32(IGC_PTM_CTRL, ctrl);
 
 		/* Force the first cycle to run. */
-		wr32(IGC_PTM_STAT, IGC_PTM_STAT_VALID);
+		igc_ptm_trigger(hw);
+
+		if (readx_poll_timeout_atomic(rd32, IGC_PTM_STAT, stat,
+					      stat, IGC_PTM_STAT_SLEEP,
+					      IGC_PTM_STAT_TIMEOUT))
+			netdev_err(adapter->netdev, "Timeout reading IGC_PTM_STAT register\n");
 
+		igc_ptm_reset(hw);
 		break;
 	default:
 		/* No work to do. */