i2c: i801: Don't generate an interrupt on bus reset

Now that the i2c-i801 driver supports interrupts, setting the KILL bit
in a attempt to recover from a timed out transaction triggers an
interrupt. Unfortunately, the interrupt handler (i801_isr) is not
prepared for this situation and will try to process the interrupt as
if it was signaling the end of a successful transaction. In the case
of a block transaction, this can result in an out-of-range memory
access.

This condition was reproduced several times by syzbot:
https://syzkaller.appspot.com/bug?extid=ed71512d469895b5b34e
https://syzkaller.appspot.com/bug?extid=8c8dedc0ba9e03f6c79e
https://syzkaller.appspot.com/bug?extid=c8ff0b6d6c73d81b610e
https://syzkaller.appspot.com/bug?extid=33f6c360821c399d69eb
https://syzkaller.appspot.com/bug?extid=be15dc0b1933f04b043a
https://syzkaller.appspot.com/bug?extid=b4d3fd1dfd53e90afd79

So disable interrupts while trying to reset the bus. Interrupts will
be enabled again for the following transaction.

Fixes: 636752bcb517 ("i2c-i801: Enable IRQ for SMBus transactions")
Reported-by: [email protected]
Signed-off-by: Jean Delvare <[email protected]>
Acked-by: Andy Shevchenko <[email protected]>
Cc: Jarkko Nikula <[email protected]>
Tested-by: Jarkko Nikula <[email protected]>
Signed-off-by: Wolfram Sang <[email protected]>

0 files changed, 0 insertions, 0 deletions