openssl/apps/ecparam.c, branch OpenSSL_1_1_0

Copyright consolidation 01/10

2016-05-17T18:19:19Z

Reviewed-by: Richard Levitte Reviewed-by: Kurt Roeckx

argv was set but unused

2016-02-20T13:53:53Z

Also gives an error message when you gave it a parameter it didn't expect. Reviewed-by: Rich Salz MR: #2009

Use NON_EMPTY_TRANSLATION_UNIT, consistently.

2016-02-10T01:13:29Z

This also closes RT 4123 Reviewed-by: Richard Levitte

Fix memory leak and print out keygen errors.

2016-02-01T15:11:18Z

Reviewed-by: Rich Salz

Remove useless code

2015-10-23T17:52:08Z

RT#4081 Reviewed-by: Rich Salz Reviewed-by: Richard Levitte

Centralise loading default apps config file

2015-10-12T21:31:00Z

Loading the config file after processing command line options can cause problems, e.g. where an engine provides new ciphers/digests these are not then recoginised on the command line. Move the default config file loading to before the command line option processing. Whilst we're doing this we might as well centralise this instead of doing it individually for each application. Finally if we do it before the OpenSSL_add_ssl_algorithms() call then ciphersuites provided by an engine (e.g. GOST) can be available to the apps. RT#4085 RT#4086 Reviewed-by: Richard Levitte

Enable -Wmissing-variable-declarations and

2015-09-11T03:51:55Z

-Wincompatible-pointer-types-discards-qualifiers (the latter did not require any code changes). Reviewed-by: Rich Salz

Change the way apps open their input and output files

2015-09-05T23:35:54Z

The different apps had the liberty to decide whether they would open their input and output files in binary mode or not, which could be confusing if two different apps were handling the same type of file in different ways. The solution is to centralise the decision of low level file organisation, and that the apps would use a selection of formats to state the intent of the file. Reviewed-by: Tim Hudson

Exit on error in ecparam

2015-07-09T19:42:52Z

Reviewed-by: Tim Hudson

RT2547: Tighten perms on generated privkey files

2015-06-15T22:26:56Z

When generating a private key, try to make the output file be readable only by the owner. Put it in CHANGES file since it might be noticeable. Add "int private" flag to apps that write private keys, and check that it's set whenever we do write a private key. Checked via assert so that this bug (security-related) gets fixed. Thanks to Viktor for help in tracing the code-paths where private keys are written. Reviewed-by: Viktor Dukhovni